UK Battery Charger store >> Battery Charger >> ANSI Battery Charger suitable for ANSI

Please Press 'Ctrl + F' to locate your drill battery number or Machine Model.

Use our cross-reference information to choose the correct ANSI Battery Charger on Toppower(UK) Shipping. select high quality and lower price ANSI battery charger part NO. or the machine NO. bellow:
This Battery Charger can replace the following part numbers of ANSI
5032LC
This is also compatible with the following models of ANSI
Ansi Common Photo (Camera)Model

ANSI Battery Charge Tips

1. If your ANSI battery can not charge with our ANSI battery charger, what is matter with the charger?

I think there is some electrical contact problem in your ANSI charger and you can fix it yourself in a few minutes.

(1). Remove your ANSI charger from the DC adapter.
(2). There are two hooks at the bottom of the ANSI charger.
(3). Your can release the top charging plate by pushing the hooks with two fingers.
(4). The top charging plate will release from the top.
(5). At the bottom of the charging plate, there will be three metallic contacts.
(6). Try pulling all the contacts so that it will avoid the bad connection.
(7). Slowly re-insert the charging plate to the charging base.
(8). Re-connect the DC adapter and your ANSI charger should work.

Good luck and if there is still other problem, please don't hesitate to send us a mail again.

2. What does the light indicator mean when charging ANSI battery ?

(1).Plug the AC power adapter in a wall outlet.
(2). Connect the AC Power adaptor supplied with ANSI charger to the DC in jack.
(3). "Status" indicator shows RED when the ANSI charger is ready and "Charger" indicator shows flashing Green when waiting for battery pack.
(4). Slide ANSI battery pack in the charger and "Charger" indicator goes RED when charging.
(5). "Charger" indicator show RED and GREEN alternatively when ANSI battery pack has more than 90% charged.
(6).When the ANSI battery pack is fully charged, the "Charger" indicator shows a steady green.
(7). After the ANSI battery pack fully charged, slide the battery pack out.
(8). Unplug DC power, "CHARGE" and "STATUS" indicators go out.

3.How to Test a ANSI Battery Charger

Whether you're unsure that your ANSI battery charger is working properly. Running a test on you ANSI battery charger is an easy process to solve this problem.

(1).Plug in your ANSI charger to an electrical outlet. Remove any batteries you may have charging in the unit.

(2).Turn on your voltmeter unit. Be sure there's power getting to the meter. Plug in the test probes into the voltmeter according to the meter's instructions. Set the selector switch to the highest level for DC Volt or whatever is recommended in the meter's instructions.

(3).Take a battery or battery pack that's compatible to your battery charger. Make sure the ANSI battery has no corrosion and is not leaking fluid. Touch the positive end of the battery with the red probe. Take the black test probe and place it on the negative side of the battery.

(4).Check the readout on the voltmeter and see where the pointer is indicating to. If it's on the left side, or negative side, switch the test probes. If it's on the right side, it will show that the ANSI battery is receiving some charge. Where it points to on the meter will determine how much charge it received.

(5).Check the ANSI battery charger to see how much power it's giving off, if you continue to receive a negative reading from the batteries. A negative reading will indicate a bad battery charger, and you should replace it. If the charger has sufficient amount of power flowing through it, it's more than likely the ANSI batteries are bad and just won't hold a charge.